Kenwood AMPLIFIER/TUNER R-K1000 - Manual (Page 57)

TIMER DISPLAY SLEEP
MODE
FLAT TONE
ENTER
TUNING
RANDOM REPEAT P.MODE
AUTO / MONO
ClearA
VOL
RC-R0830E
P.CALL
TUNER D.AUDIO CD
BAND
AUX PHONO TAPE
D-IN1 D-IN2 D-IN3
ROOM EQ
MUTE
CLEAR
DIMMER
MODE
SOUND
PRESET
Setting the Timer Setting the Timer
57 English
To cancel (off ) or reset (on) the timer
When the system is turned on, press the [TIMER] key.
The setting changes each time you press the [TIMER] key.
„
z
Press the power [ K] key to turn the power OFF.
The Standby indicator on the main unit lights orange.
If the indicator lights red, set the clock to the correct time. z
13 13
lit lit
unlit lit
PROG. 1 set to on PROG. 2 set to on
PROG. 1 and 2 set to
on Timer off
If there has been a power failure or the system was unplugged
from the wall outlet for some time, the Standby indicator
lights red. In that case, set the time again. (P.52) z
To modify the program settings, redo the timer settings from the
beginning.
When the system is in Standby mode, you can confi rm the timer setting
(on or off ) for 5 seconds by pressing the [
F] key.
z
z
Select the input source.
Press the [ A] or [B] key.
The input source changes as shown below each time you press the key.
12 12
If you select an input source other than “TUNER”, this completes the
settings and “COMPLETE” is displayed briefl y, after which the original
display reappears.
If you select “TUNER”, use the [ A] or [B] to select a preset number and
then press the [ENTER] key. This completes the settings and “COMPLETE”
is displayed briefl y, after which the original display reappears.
z
z
Press the [ENTER] key.
TUNER CD TAPE AUX
D-IN3 D-IN2 D-IN1