Creating a mirrored-striped set (raid 10), Creating parity raid (raid 5), Creating jbod sets – Lindy 51127 User Manual
Page 6
- 6 -
2. Select
Create RAID set.
Press
Enter
.
3. Select
RAID 1
then press
Enter
.
4. Select
Auto configuration
. Press
Ente
r.
5. Press
Y
to save your settings.
6. Press
CTRL+E
and then press
Y
to exit the setup.
7. Continue with conventional Fdisk and Format steps as if you are installing a conventional
hard drive.
8.Your RAID configuration is complete. Please proceed to software installation section.
3.3. Creating a Mirrored-Striped Set (RAID 10)
1. As the BIOS boots, press CTRL+S or F4 to enter the raid bios utility.
2. Select
Create RAID set
. Press
F2
.
3. Select
RAID 10
then press
Ente
r.
4. Select
Auto config
. Press
Ente
r.
5. Press
Y
and then press ESC to exit the setup.
6. Continue with conventional Fdisk and Format steps as if you are installing a conventional
hard drive.
7.Your RAID configuration is complete. Please proceed to software installation section.
3.4. Creating Parity RAID (RAID 5)
1. As the BIOS boots, Press CTRL+S or F4 to enter the raid bios utility.
2. Select
Create RAID set.
Press
Enter
.
3. Select
RAID 5
then press
Enter
.
4. Select
Auto configuration
. Press
Ente
r.
5. Press
Y
to save your settings.
3.5. Creating JBOD Sets
1. As the BIOS boots, Press CTRL+S or F4 to enter the raid bios utility.