Lindy 51127 - Manual (Page 7)

- 7 -
2. Select Create RAID set. Press Enter .
3. Select JBOD (Single) then press Enter .
4. Select JBOD Drives . Press Ente r.
5. Select RAID size . Press Ente r.
6. Press Y to save your settings.
3.6. Creating Spare Drive
1. As the BIOS boots, Press CTRL+S or F4 to enter the raid bios utility.
2. Select Create RAID set. Press Enter .
3. Select Spare Drive then press Enter .
4. Select Spare Drives . Press Ente r.
5. Select RAID size . Press Ente r.
6. Press Y to save your settings.
3.7. Deleting RAID Sets
1. As the BIOS boots, Press CTRL+S or F4 to enter the raid bios utility.
2. Select Delete RAID set. Press Enter .
3. Answer Y to remove the RAID set. If the RAID set being deleted is a Striped set, then all of
the data will be lost. If the set being deleted is a Mirrored set, then the data will remain
intact and accessible on both drives.
3.8. Rebuilding Mirrored Sets (RAID 1)
1. After replacing the failed hard drives boot the BIOS, Press CTRL+S or F4 to enter the
raid bios utility.
2. Select Rebuild RAID 1 set. Press Enter .
3. Select Rebuild Hard Drive. Press Enter .
4. Answer Y to rebuild the Mirrored set of hard drive.
3.9. Resolving Conflict
When a RAID set is created, the metadata written to the disk includes drive
connection information (Primary and Secondary). If, after a disk failure, the