Lindy 51127 - Manual (Page 9)

- 9 -
3. Select 'Search for a suitable driver for my device (Recommended)' and Click 'Next'.
4. Insert the Driver CD in your CD-ROM/DVD drive, check
Specify a location , uncheck
the other boxes, click Next, type in E:\ (If your CD-ROM/DVD is E :\). Click Browse .
5. Points specify a location, example E:\ Raid5 SATA2_4Port \ SiI3124 \ Windows \
Driver , click Open then OK .
6. When the wizard indicates that it found a driver for the device click 'Next'.
7. If the 'Digital Signature Not Found' dialog appears, click 'Yes' to continue installing the
driver.
8. The wizard will now copy the required files to the system and start the driver. After
starting the driver the wizard will display a completion dialog, click 'Finish' to exit the
wizard.
9. See instructions in section 4.3 to verify controller was installed correctly.
4.3. Verifying controller installation under Windows
2000/XP/2003
1. Right click on 'My Computer' icon, select 'Properties', left click on 'Hardware' tab and
then on 'Device Manager' button.
2. Double click on 'SCSI and RAID Controllers', If there is no yellow '!' or '?' in front of
'Silicon Image SiI 3124 SoftRaid5 Controller', the driver is started correctly.
4. To view information about the devices attached to the controller, use the SiICfg
Utility and click on the device from the list.
4.4. Update new driver on Windows 2000/XP/2003 with existing
driver
1. Right click on 'My Computer' and select 'Properties'. Under the 'System
Properties' section, click on 'Hardware' tab and then on 'Device Manager' click 'SCSI
and RAID Controller' and right click 'Silicon Image SiI 3124 SoftRaid5 Controller'.
2. Click 'Driver', 'Update Driver' and select 'Search for a suitable driver for my
device[Recommended]'. Insert the Driver CD. Press 'Enter' and select 'E:\ Raid5
SATA2_4Port\SiI3124\Windows \Driver'. Click 'Next' and complete the driver installation.
3. System will go through the enumeration process and install the driver. At the end of the
process, click 'Yes' to reboot your system when necessary.
4. See instructions in section 4.3 to verify controller was installed correctly.