Lanier LD235 - Manual (Page 113)

Accessing User Tools (Copier/Document Server Features)
103
4
Input/Output
❖ Switch to Batch (SADF)
You can select to have Batch mode
or SADF mode displayed when
you press the [Special Original] key.
See p.14 “Batch mode”.
Note
❒ Default: Batch
❖ SADF Auto Reset
In SADF mode, an original must be
set within a specified time after the
previous original has been fed.
You can adjust this time from 3 to
99 seconds in increments of 1 sec-
ond .
Note
❒ Default: 5 seconds
❖ Rotate Sort: Auto Paper Continue
You can specify to continue copy-
ing when paper of the required ori-
entation has run out during rotate-
sorting. See p.33 “Rotate Sort”.
Note
❒ If you select [No] :
• When paper of the required
orientation runs out, the ma-
chine stops copying and
prompts you to supply copy
paper. After you have loaded
paper, the machine will con-
tinue copying.
❒ If you select [Yes] :
• Copying continues using copy
paper of a different orienta-
tion. The copy job will finish
even if you have left the ma-
chine.
❒ Default: No
❖ Auto Sort
You can specify whether Sort
mode is selected when the ma-
chine is turned on or the mode is
cleared.
Note
❒ Default: No
❖ Memory Full Auto Scan Restart
When memory becomes full while
scanning originals, the machine
can make copies of scanned origi-
nals first, and then automatically
proceed scanning remaining origi-
nals.
You can enable or disable this
function.
Note
❒ If you select [No] :
• When memory becomes full,
the machine stops operation
allowing you to remove the
copy pages delivered on the
output tray.
❒ If you select [Yes] :
• You can leave the machine
unattended to make copies,
but sorted pages will not be
sequential.
❒ Default: No
❖ Select Stack Function
Specify whether Stack or Rotate
Sort has priority to be shown on
the initial display.
Note
❒ Default: Stack
❒ An optional finisher is required
to use this function.