Life Fitness 8211 - Manual (Page 5)

5
STEP 4:
FIGURE 4
HEAD PLATE
TOWER
• Tilt the GUIDE RODS back and remove the HEAD PLATE
ASSEMBLY, and the twenty WEIGHT PLATES.
• Unbolt the old WEIGHT STACK SHAFT from the HEAD
PLATE and replace it with the new 25 HOLE WEIGHT
STACK SHAFT (1). (NOTE: The bolt hole in the HEAD
PLATE should be on top. Please discard the old WEIGHT
STACK SHAFT.)
• Attach the WEIGHT STACK LABELS (4) (#’s 220-260) or
(5) (21-25) to the five WEIGHT PLATES (2) as shown on
FIGURE 4.
• Insert the two GUIDE RODS through the two WEIGHT
STACK CUSHIONS into the base of the TOWER as
shown in FIGURE 4. Lubricate the GUIDE RODS with a
silicon or teflon spray that is available at most hardware
stores.
• USING EXTREME CARE, slide the five new WEIGHT
PLATES (6) and the previous twenty WEIGHT PLATES
down over the GUIDE RODS onto the WEIGHT STACK
CUSHIONS. (NOTE: Make sure that the key holes of the
WEIGHT PLATES all face the same way.)
• Carefully Slide the new HEAD PLATE ASSEMBLY down
over the GUIDE RODS onto the weight stack as shown in
FIGURE 4.
1
6
GUIDE ROD
WEIGHT
STACK
CUSHION
4 5