Life Fitness x3i - Manual (Page 8)

8
1.4 S
ETUP
Tools required: Socket set, Phillips Screwdriver, 9/16 open ended wrench
Please read instructions carefully before assembly. Be sure to assemble the unit where it is to be used.
S
TEP
1
Remove machine from packaging. Carefully lay out and count each part before assembly. Refer to the parts list on page 5 of
this manual.
S
TEP
2
Assemble upright tube assembly to base frame:
1. Lay upright assembly on floor in front of base frame.
2. Connect upper wire harness to lower wire harness. Insert connected plugs from electronic cables into wiring hole on upright
tube assembly.
3. Position upright tube assembly between plates on front of base frame. Feed excess electronic cable into base frame.
NOTE: This step could require two people.
4. Line up holes on plates with holes on upright tube assembly.
5. Connect upright tube assembly to base frame using four (#5) 2-3/4” bolts, eight (#9) washers (4 on each side) and four (#7)
low profile nylock nuts.
DO NOT FULLY TIGHTEN AT THIS POINT.
CAUTION: The electronic cable may obstruct the connecting holes. If this happens, gently pull on the end of the cable
at the top of the upright tube assembly to clear the hole. Do not force bolt through hole if the cable is obstructing the
bolt, as damage to wiring my result.
(#9)
(#9)
(#7)
(#5)