Safety instructions, Glossary of symbols, Save these important safety instructions – Liebert Integrated Secured Protection User Manual

Page 3

Advertising
background image

3

SAVE THESE IMPORTANT SAFETY INSTRUCTIONS

WARNING: Do not attempt to service this product yourself. Opening or removing

covers will risk exposure to dangerous voltages. Refer all servicing to qualified service

personnel.

1. SAVE THESE INSTRUCTIONS. THIS

MANUAL CONTAINS IMPORTANT
SAFETY INSTRUCTIONS. Read all safety
and operating instructions before operating
the Little Glass House (LGH). Adhere to all
warnings on the unit and in this manual.
Follow all operating and user instructions.

CONSERVER CES INSTRUCTIONS.
CETTE NOTICE CONTIENT DES
INSTRUCTIONS IMPORTANTES
CONCERNANT LA SÉCURITÉ.

2. This product is designed for

Commercial/Industrial use only. It is not
intended for use with life support and other
designated “critical” devices. Maximum load
must not exceed that shown on the LGH
rating label. If uncertain, consult your
dealer. See Limited Warranty.

3. The LGH must be permanently connected to

the input AC/mains supply and protected by
a suitable circuit breaker or fuse.

4. The LGH must be powered from a suitable

single phase supply rated in accordance
with the equipment data plate, and must be
suitably grounded/earthed.

5. The utility/mains supply socket or means of

isolation must be within 2 meters of the
equipment and accessible to the operator.

6. This equipment complies with the

requirements of the EMC Directive
89/336/EEC and the published technical
standards. Continued compliance requires
installation in accordance with these
instructions and the use of manufacturer
approved accessories with output cables not
exceeding 10 meters (30 ft.) in length. Use
a shielded cable for the external
communications interface.

7. Route power supply cords so they are not

walked on or pinched.

8. Never block or insert any object into the

ventilation holes or other openings.
Maintain a minimum clearance of 305 mm
(12 inches) in front and rear of the LGH for
proper air flow and cooling.

9. Operate the LGH in an indoor environment

only with an ambient temperature range of
0° C to +40° C (32° F to +104° F). Install it
in a clean environment, free from moisture,
flammable liquids, gasses, or corrosive
substances.

10. Storing magnetic media on top of the LGH

may result in data loss or corruption.

11. Do not stand beverage containers on the

LGH.

12. This equipment can be operated by

individuals without previous training.

13. Qualified Personnel should be consulted

for the following conditions:
- Power cable is damaged
- Liquid spilled into product
- LGH does not operate when operating
instructions have been followed.

Glossary of Symbols

Indicates weight

Indicates a Ground/Earth
connection

Indicates a Warning - Hazardous
Voltage Present

Consult the user’s manual for
additional information

Indicates Caution: Note the
accompanying instruction

Indicates alternating current

Advertising