Troubleshooting & repair, Drive motor removal and replacement (continued) – Lincoln Electric LN-9 SVM127-A User Manual
Page 125
Advertising
TROUBLESHOOTING & REPAIR
F-67
F-67
LN-9 Wire Feeder
13. Lift the right side cover assembly and care-
fully lift and slide the motor and wire drive
assembly partially out of the LN-9 box
assembly. See Figure F.27.
14. Using the 1/2" wrench, remove the four bolts
and associated washers holding the glastic
mounting board and mylar insulator to the
gear box assembly.
NOTE:
Four-roll drive units will require the
removal of a 1/2" bolt mounting the reed switch
copper energizer to the glastic plate.
FIGURE F.27 – MOTOR AND WIRE DRIVE REMOVAL
GLASTIC
MOUNTING
BOARD
MYLAR
INSULATOR
MOUNTING
BOLTS (4)
DRIVE MOTOR REMOVAL AND REPLACEMENT
(continued)
Advertising