Lenovo 3000 G230 - Manual (Page 35)

Chapter 2. Using Your Computer
27
Changing or Removing the Supervisor Password
To change the password, do the following:
1
Select Set Supervisor Password, and press the Enter key. The Set
Supervisor Password window opens.
2
Select Enter Current Password and type in the correct password. Then
press the Enter key once to move to the Enter New Password field,
type in a new supervisor password.
3
Press the Enter key once to move to the Confirm New Password field.
Retype the password you just entered to verify it.
4
Commit your password to memory, and press the Enter key.
To remove password, do the following:
1
Select Set Supervisor Password, and press the Enter key.
2
Select Enter Current Password and type in the correct password, and
finally press the Enter key thrice.
Note:
Make sure Password on boot is set to Enabled if you desire password
protection at power on.
Lenovo G230 UG V1.0_en.book Page 27 Monday, July 28, 2008 7:29 PM