LSI U160 - Manual (Page 23)

3.75 pc 10.25 pc 11.25 pc 38.25 pc
4.333 pc
48.583 pc
52.5 pc
34.5 pc
44.25 pc
Detailed Installation Procedure 2-3
Step 12. Make all external SCSI bus connections.
Step 13. Refer to the PCI Storage Device Management System SDMS
4.0 User’s Guide (or the guide for the software you will use) to
load the driver software for your particular operating system.
Remember: The SCSI bus requires proper termination, and no
duplicate SCSI IDs.
2.2 Detailed Installation Procedure
This section provides step-by-step instructions for installing the LSIU160,
and connecting it to your SCSI peripherals. If you are experienced in
these tasks, you may prefer to use
Section 2.1, “Quick Installation
Procedure.”
2.2.1 Before You Start
Before starting, look through the following task list to get an overall idea
of the steps you will be performing. If you are not confident you can
perform the tasks as described here, LSI Logic suggests getting
assistance.
•
Open your PC cabinet and select an appropriate open PCI slot
•
Insert the host adapter board
•
Connect the internal and external SCSI peripherals
•
Terminate the SCSI bus
•
Set the peripheral SCSI IDs
•
Make any configuration changes
•
Close your PC cabinet
•
Install the software
The SCSI host adapter acts on your computer’s behalf as the host to
your suite of SCSI peripherals. Each chain of SCSI peripheral devices
and their host adapter work together, and are referred to as a SCSI bus.
Each SCSI host adapter that you install can act as host for up to
15 peripheral devices, not including the adapter itself.