Lennox Hearth ELITE EDVI25 - Manual (Page 13)

13
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
8. Place the glowing embers on the burner as shown in Figure 27.
One package of ember material has been included with this log set
You will not need to use the entire bag.
IMPORTANT: The quantity and placement of the ember material can
affect insert performance therefore it is very important that it be placed
as shown in Figure
27.
a. Unpackage and divide the fi ne ember material (mineral wool) into
dime-sized fl uffy pieces.
b. Distribute the pieces over the top of the front burner ports, fi lling the
area in front of the forward logs.
Figure 25
7. Install the Top Right Log into the corresponding indentations on
Front Center Log and front right twig as shown in Figure 26.
Figure 26
Front Center Log
Top Right Log
Figure 27
Figure 28
Embers
Vermiculite
Carefully install the seven-piece log set into the fi rebox as shown in
these instructions. All logs should fi t onto corresponding pins and/or
log stoppers. This will ensure a proper fl ame and safe combustion.
2. Place the Rear Log onto the 2 corresponding locating pins at the
back of the fi rebox as shown in Figure 29.
1. Place some vermiculite around the burner as shown in Figure 29
(the entire bag of vermiculite will NOT be used).
LOGS, VERMICULITE AND EMBERS - Model EDVI35
WARNING: IF LOGS ARE NOT INSTALLED ACCORDING TO THE
DIRECTIONS SHOWN HERE, FLAME IMPINGEMENT AND IMPROPER
COMBUSTION COULD OCCUR AND RESULT IN SOOT AND/OR EXCES-
SIVE PRODUCTION OF CARBON MONOXIDE (CO), A COLORLESS,
ODORLESS, TOXIC GAS.