Lindy Smart - Manual (Page 4)

User Manual English
2
Features
ƒ Provides a convenient and secure method of remotely locating workstations or
servers without compromising convenience and control
ƒ Distances of up to 150m supported between local and remote units
ƒ Dual console operation – control your computer / KVM Switch from both local and
remote locations
ƒ Remote Receiver unit features a built-in KVM Switch – allowing control of a local PC
ƒ High-resolution video support:
1280 x 1024 @ 100m
800 x 600 @ 150m
ƒ Adjustable VGA Tuning control to improve video quality
ƒ Easy, user-friendly installation – no software required
ƒ Supports PS/2 keyboard/mouse and VGA monitor signals
ƒ Compatible with all major operating systems
Package Contents
ƒ Local Transmitter unit
ƒ Remote Receiver unit
ƒ 9V DC, 500mA Power Adapter (for the Remote Receiver unit)
ƒ 1 x 3-in-1 KVM cable
ƒ This
manual
System Requirements
ƒ VGA, SVGA or Multisync monitor for each console. The monitor should be capable
of supporting the highest resolution you will be using on any computer in the
installation
ƒ PS/2 keyboard and mouse for each console
Note: If you experience problems with mouse functionality, try using the same brand and
model of mouse on both local and remote units.
Additional Cable Requirements
If you want to connect a workstation to the remote receiver you require a 3-in-1 KVM cable (not
included). For optimum signal integrity and to simplify the layout, we strongly recommend that
you use high quality LINDY 3-in-1 KVM cables. The following lengths are available:
1m No. 33711
2m No. 33712
3m No. 33713
5m No. 33714
For connecting the local and remote units, Category 5 UTP, STP, FTP or PIMF cable is the
minimum requirement. Using lower quality cable will result in a degraded video signal.
See
www.lindy.com for our extensive range of CAT5 and higher cable.