Lindy Smart - Manual (Page 7)

User Manual English
5
LED Status Indicators
Remote Receiver Unit
LED STATUS MEANING
LOCAL
RED The console is switched to the workstation
LOCAL
FLASHING
RED The console is switched to the workstation, but the
PC is turned off or not connected.
REMOTE RED
The console is switched to the remote computer /
KVM Switch
REMOTE SOLID
The console is switched to the remote computer /
KVM Switch but the computer(s) are not connected or
are switched off.
Local Transmitter Unit
LED STATUS MEANING
POWER OFF No computer(s) connected to the Local Transmitter.
POWER RED Computer(s) connected to the Local Transmitter.
STATUS
FLASHING
RED Flashes when there is local console keyboard/mouse
activity.
REMOTE OFF
When there is no console keyboard/mouse activity
this LED remains off.
Keyboard hotkey commands (Remote Receiver only)
Both consoles of the extender can have simultaneous access to the connected server or KVM
switch. Active keyboard and mouse access is governed by a short timeout period.
When you access from the local console at the Transmitter unit you can use operate your KVM
switch using its regular keyboard hotkeys. When you use the remote console you have two
additional hotkeys that allow you to switch between your workstation and remote KVM access:
You can switch console control at the Remote Receiver unit from PC port (connected
workstation) to RJ-45 port (the PC / KVM switch connected to the Local Transmitter) using this
simple hotkey command:
Scroll
Lock
Scroll
Lock
C + +
= select ‘PC Port’ or ‘RJ-45 Port (Remote KVM access)
When switching, the appropriate LOCAL and REMOTE LED will light on the Remote unit. You
will also hear an audible confirmation. You can enable and disable this audible beeper using
this hotkey command:
Scroll
Lock
Scroll
Lock
Q + + = Beeper ON/OFF