Lindy Smart - Manual (Page 8)

User Manual English
6
Troubleshooting
There are no LED’s illuminated on the Remote Receiver unit
ƒ Ensure that the AC Adapter is plugged into the mains and the jack is plugged into
the socket on the Remote Receiver.
ƒ Verify that the connected PC is switched on. Otherwise it may result in display
problems.
There is no video signal displayed on the monitor
ƒ Check that the VGA cables and CAT5 cable are properly connected to the
respective ports on the Receiver and Transmitter units.
ƒ Ensure the VGA cables are correctly connected to the computers
ƒ Make sure the power adapter is connected to the Receiver
ƒ If you still can’t see a picture, try connecting with a short CAT5 patch cable to make
sure there is not a fault with the CAT5 cable.
The display is ‘foggy’ or unclear.
ƒ Check that the VGA cables are properly connected.
ƒ Try adjusting the VGA Tuning control as described in section Installation
ƒ Ensure that the VGA resolution is not set too high for the length of Ethernet cable
that is used.
ƒ Try a higher specification or shorter length CAT5, 5e or 6 cable
ƒ Try reducing the display resolution.