LG LRE30755S - Manual (Page 8)

Replace the access cover on the range back. To
replace the wire cover, insert double projections in the
pockets located below the opening and tighten the
three screws.
ANTI-TIP DEVICE INSTALLATION
Note
To install Anti-tip bracket, release the leveling leg. A
minimum clearance of 0.65”(16.5mm) is required
between the range bottom and the kitchen floor.
1. Locate the bracket using the template
An Anti-tip bracket is packaged with template. The
instructions include necessary information to
complete the installation.
Read and follow range installation instruction sheet
(template).
2. Level the range
Level the range by adjusting the leveling legs with a
wrench.
WARNING
• To reduce the risk of tipping, the appliance must be
secured by properly installed anti-tip devices packed
with the appliance.
• See instructions to install (supplied with bracket).
• Unless properly installed, the range could be tipped
by stepping or sitting on the door. Injury may result
from spilled hot liquids or from the range itself.
8
Use a spirit level to check your adjustments. Place the
level diagonally on the oven rack, and check each
direction for level.
First check direction 1 .
After check direction 2 .
If the spirit level doesn’t show
level on the rack, adjust the
leveling legs with a wrench.
FINAL INSTALLATION
• Move range close enough to the opening to plug
into the receptacle.
• Slide range into position insuring that the left back
leg slides under the anti-tip bracket. Range will sit 0”
away from the back wall when properly installed.
• Carefully tip range forward to insure that the anti-tip
bracket engages the range back brace and prevents
tip-over.
• Turn on electrical power. Check range for proper
operation as described in owner’s manual.
5
6
Part 4 INSTALL THE RANGE