Warning, Avertissement – Lennox International Inc. MERIT PLUS MPB3530CNM-B User Manual

Page 23

Advertising
background image

23

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

LENNOX HEARTH PRODUCTS • MERIT PLUS

®

B-VENT GAS FIREPLACES (MPB33/35/40/45) • INSTALLATION INSTRUCTIONS

Millivolt SIT Systems

Propane Gas to Natural Gas

Conversion Kits

Models

Catalog No.

MPB33

H2010

MPB35

H2012

MPB40

H2014

MPB45

H2016

Table 9: Millivolt Conversion Kits

Millivolt SIT Systems

Natural Gas To Propane Gas

Conversion Kits

Models

Catalog No.

MPB33

H2009

MPB35

H2011

MPB40

H2013

MPB45

H2015

Electronic SIT Systems

Propane Gas To Natural Gas

Conversion Kits

Models

Catalog No.

MPB33

H8631

MPB35

H8633

MPB40

H8635

MPB45

H8637

Table 10: Electronic Conversion Kits

In Canada:

THE CONVERSION SHALL BE CARRIED
OUT IN ACCORDANCE WITH THE
REQUIREMENTS OF THE PROVINCIAL
AUTHORITIES HAVING JURISDICTION
AND IN ACCORDANCE WITH THE
REQUIREMENTS OF THE CAN/
CGA-B149.1 INSTALLATION CODE.

LA CONVERSION DEVRA ÊTRE
EFFECTUÉE CONFORMÉMENT AUX
RECOMMANDATIONS DES AUTORITÉS
PROVINCIALES AYANT JURIDICTION
ET CONFORMÉMENT AUX EXIGENCES
DU CODE D'INSTALLATION CAN/
CGA-B149.1.

Gas conversion kits are available to adapt
your appliance from the use of one type of
gas to the use of another. These kits contain
all the necessary components needed to
complete the task including labeling that
must be affi xed to ensure safe operation.

Kit part numbers are listed here and the
following steps detail the conversion
procedure. Refer to the instructions provided
with the conversion kit when performing any
gas conversion.

GAS CONVERSION KITS

INSTALLATION INSTRUCTIONS

Step 1. TURN OFF THE GAS SUPPLY TO THE
APPLIANCE and disconnect power supply at
the circuit breaker. Ensure appliance is cold.

CAUTION: THE GAS SUPPLY SHALL BE
SHUT OFF PRIOR TO DISCONNECTING
THE ELECTRICAL POWER, BEFORE
PROCEEDING WITH THE CONVERSION.

ATTENTION: AVANT D’EFFECTUER
LA CONVERSION, COUPEZ D’ABORD
L’ALIMENTATION EN GAZ, ENSUITE,
COUPEZ L’ALIMENTATION ÉLECTRIQUE.
Step 2.
Open the lower control compartment
door (see Figure 19 on Page 13) by pushing
on the right top corner of the door (the door
is hinged at the bottom).

[Optional] Remove the control compartment
door by sliding the hinge pin, located at the
door’s left side, to the right until it disengages
from the left corner post hole. Pull the
control compartment door diagonally to the
left, away from the fi replace.

Step 3. Remove the front glass door/frame
from the appliance (see Page 19).

Electronic SIT Systems

Natural Gas To Propane Gas

Conversion Kits

Models

Catalog No.

MPB33

H8632

MPB35

H8634

MPB40

H8636

MPB45

H8638

WARNING

This conversion kit shall be installed by a qualifi ed service agency in
accordance with the manufacturer’s instructions and all applicable codes
and requirements of the authority having jurisdiction. If the information in
these instruction is not followed exactly, a fi re, explosion or production of
carbon monoxide may result causing property damage, personal injury
or loss of life. The qualifi ed service agency is responsible for the proper
installation of this kit. The installation is not proper and complete until the
operation of the converted appliance is checked as specifi ed in the manu-
facturer’s instructions supplied with the kit.The qualifi ed service agency
performing this installation assumes responsibility for this conversion.

AVERTISSEMENT

Cette trousse de conversion doit être installée par un technicien agréé,
selon les instructions du fabricant et selon toutes les exigences et tous les
codes pertinents de l’autorité compétente. Assurez-vous de bien suivre
les instructions dans cette notice pour réduire au minimum le risque
d’incendie, d’explosion ou la production de monoxyde de carbone pouvant
causer des dommages matériels, des blessures ou la mort. Le tecnicien
agréé est responsable de l’installation de cette trousse. L’installation n’est
pas adéquate ni complète tant que le bon fonctionnement de l’appareil
converti n’a pas été vérifi é selon les instructions du fabricant fournies avec
la trousse. Le fournisseur de service qualifi é ayant réalisé l'installation
assume les responsabilités liées à la conversion.

Advertising