Reveal corner adjusted for arch face, Template – Lennox Hearth C42 User Manual

Page 12

Advertising
background image

Figure 9

Figure 10

Figure 15

Figure 14

Figure 13

Figure 12

1

The fireplace face dimensions are:

Arch Face

Adjustment prior to arched face installation:

The corners of the 1” (25mm) reveal around the fireplace opening need
to be adjusted prior to installing an arched face (see drawings below).
Remove screws A and loosen screw B. Rotate the corner downward
bending the metal at pivot point C until the holes from which screws A
were removed line up with the lower set of holes. Reinstall screws A and
tighten screw B. When finished, the corners should look like the corner
below at the far right.

Platform to raise fireplace to accommodate a

hearth extension greater than 1” in thickness.

Facing Greater Than 1” (5mm) Thick:

If the combined thickness of the facing material (eg. brick or cultured
stone) and concrete board is greater than 1”, then the facing material
must be placed around the face. A template (Arch #75098, Foundry™
#75035 and Louver #75101) should be used while installing the facing
material. Templates for the various faces may be purchased from your
Lennox Hearth Products dealer or a template may be made of plywood
using the dimensions listed on this page. If you choose to make a
template, 1/8” (3mm) must be added to each side and top dimension to
provide sufficient clearance so the face may be removed for access to
the firebox. Since the bottom of the fireplace face is 1” above the base
of the fireplace, 1” (25mm) must be added to the height of the template
if the template is to rest on the floor or platform on which the fireplace
is placed. It is extremely IMPORTANT that the template be centered left
to right on the glass door of the fireplace.

Traditional Face

Reveal Corner Adjusted

for Arch Face

Reveal Corner Adjusted

for Arch Face

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

6-3/8”

(670mm)

30-5/8”

(778mm)

41”

(1041mm)

51-1/” R

(1308mm)

41”

(1041mm)

30-5/8”

(778mm)

Reveal Corner

Reveal Corner

Expanded View of

Reveal Corner

Template

Template

A

B

C

Expanded View of Reveal Corner

A

A

B

A

C

Advertising