Lindy 70538 - Manual (Page 11)

- 11 -
Reboot the system if your Windows ME drive is connected on the
SiI 3112 Controller.
4.8.Verifying The installation under Windows 98SE and ME
Follow the instructions in this section to verify that the controller was installed
correctly.
1. Right click on 'My Computer' icon, select 'Properties', left click on 'Device Manager'
tab.
2. Double click on 'System devices', then left click on 'PCI standard PCI-to-PCI bridge'. If
there is no yellow '!' or '?' in front of 'PCI standard PCI-to-PCI bridge' the driver has
started correctly.
3. Double click on '1394 Bus controllers' If there is no yellow '!' or '?' in front of ' NEC
Firewarden OHCI Compliant IEEE 1394 Host Controller' the driver has started
correctly.
4. Double click 'Universal Serial Bus Controllers', If there is no yellow '!' or '?' in front of
NEC PCI to USB Enhanced Host Controller
NEC USB Open Host controller
NEC USB Open Host controller
USB Root Hub
USB Root Hub
The driver has started correctly.
5. Double click on 'SCSI Controllers', If there is no yellow '!' or '?' in front of 'Silicon
Image SiI 3112 SATARaid Controller', the driver has started correctly.
6. To view information about the devices attached to the controller, right click the 'Devices'
and select Properties from the context menu, then select the tab labeled 'General'.