Lindy 70538 - Manual (Page 9)

- 9 -
'System Properties ' , select 'Device Manager', right click on the '?PCI RAID
controller' and select 'Properties' from the context menu.
6. Click 'Driver', 'Update Driver' and select 'Automatic search for a better driver
[Recommended] '. Insert the driver diskette into floppy drive. Click 'Next' and
complete the driver installation.
7. System will go through the enumeration process and install the driver. At the end of the
process, click 'Yes' to reboot your system.
8. See instructions in section 4.8 to verify controller was installed correctly.
4.6. Windows 98SE installation
1. Power off the system. Insert Combo Card into an available PCI slot. Power up the
system.
2. During the system boot up, the Hardware Wizard will display that it found a 'PCI
standard PCI-to-PCI bridge', click 'Next'. Select 'Search for the best driver for your
device [Recommended]' and click 'Next'.
3. Select 'Floppy disk drives' and click 'Next'.
4. When the wizard indicates that it found a driver for the device click 'Next'.
Then click 'Finish' to exit the wizard.
5. The Hardware wizard will display that it found 'NEC USB Open Host Controller',
click 'Next'.
6. Select 'Search for the best driver for your device (Recommended)' and click 'Next'.
7. Select 'CD-ROM drive'. And insert CD driver into CD-ROM drive, and click 'Next'.
8. Select 'The Updated driver (Recommended)'. NEC USB Open Host Controller, and click
'Next'. And click 'Next' to continue.
9. If display 'Insert Disk' (please insert the disk labeled windows 98 second Edition
CD-ROM) and click OK, Then click 'Finish' to exit the wizard.
10. The Hardware wizard will display that it found 'NEC USB Open Host Controller',
and click 'Next'.
11. Select 'Search for the best driver for your device (Recommended)'.
Click 'Next'.
12. Select 'CD-ROM drive' click 'Next', Select 'The Updated driver (Recommended)'
NEC USB Open Host Controller, and click 'Next'. And click 'Next' to continue.
13. If display 'Insert Disk' (please insert the disk labeled windows 98 second Edition
CD-ROM) and click OK, Then click 'Finish' to exit the wizard.
14. The Hardware wizard will display that it found 'PCI Universal serial Bus', and click
'Next'.
15. Select 'Search for the best driver for your device (Recommended)'. Click 'Next',
and insert CD driver into CD-ROM drive.