Lindy 70538 - Manual (Page 8)

- 8 -
correctly.
1. Right click on 'My Computer' icon, select 'Properties', left click on 'Hardware'
tab, and then on 'Device Manager' button.
2. Double click on 'System devices', then left click on 'PCI standard PCI-to-PCI
bridge '. If there is no yellow '!' or '?' in front of 'PCI standard PCI-to-PCI bridge' the
driver has started correctly.
3. Double click on 'IEEE 1394 Bus host controllers' If there is no yellow '!' or '?' in front
of 'NEC OHCI Compliant IEEE 1394 Host Controller' the driver has started correctly.
4. Double click 'Universal Serial Bus Controllers', If there is no yellow '!' or '?' in front of
NEC PCI to USB Enhanced Host Controller
NEC PCI to USB Open Host controller
NEC PCI to USB Open Host controller
USB Root Hub
USB Root Hub
The driver has started correctly.
5. Double click on 'SCSI and RAID Controllers', If there is no yellow
'!' or '?' in front of 'Silicon Image SiI 3112 SATARaid Controller'
the driver has started correctly.
6. To view information about the devices attached to the controller, right click the 'Devices'
and select Properties from the context menu, then select the tab labeled 'General'.
4.5. Windows 98 SE /ME Fresh OS installation
Follow the instructions in this section if you are performing a new installation of
Windows 98SE/ME, and you wish to boot from a device attached to the SATA port.
You may start up the Windows 98SE/ME installation from CD. If either your Windows
98SE/ME CD or CD-ROM drive is not bootable, your can start up with floppy diskettes.
1. Power off the system. Insert Combo card into an available PCI slot. Connect serial
ATA cable(s) between the SATA port and serial ATA device(s). Power up the system.
2. Put your Windows 98SE/ME CD into the CD-ROM/DVD drive, and the Windows
98SE/ME boot diskette in the floppy drive if your system cannot boot from the CD.
3. Follow the normal Windows 98SE/ME setup instructions to select your choice for
partition and file system.
4. Wait until Windows 98SE/ME finishes installing devices, regional settings, networking
settings, components, and final set of tasks, reboot the system.
5. After the system reboots, right click on 'My Computer' and select 'Properties'. From