Lincoln Impinger II - Advantage Series - Manual (Page 24)

Impinger II – Advantage Service Manual - Domestic 24
HEATING ELEMENT - REPLACEMENT
1. Shut off power at main breaker.
2. Remove back cover.
3. Disconnect heater element wires and mark for reassembly.
4. Disconnect motor wiring and mark for reassembly.
5. Remove oven back from oven.
6. Remove fan shroud.
7. Heater element may now be unbolted and removed.
8. Check heater elements to be sure they ar the proper replacement.
9. Reassemble in reverse order. Apply anti-seize compound to back bolt threads before reassembly.
NOTE: Be sure the lead terminals are tight. If the leads are not tight, a loose connection will result, causing
arcing and lead wire burn off.
BEARING, CONVEYOR
1.
Remove conveyor from oven and place on a flat work surface.
2. Remove connecting links from conveyor belting.
3. Move drive shaft or idle shaft toward end of conveyor, and shaft with bearing will now slip out of holding
bracket.
4. Replace bearing and reassemble.