Operating instructions — electronic – Lennox Hearth 875027M User Manual

Page 20

Advertising
background image

20

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

LENNOX HEARTH PRODUCTS • MONTEBELLO

®

DV GAS FIREPLACES

(LSM40/45MN-2, LSM40/45MP-2, LSM40/45EN-2)

• CARE AND OPERATION INSTRUCTIONS

A. This appliance is equipped with an ignition device which

automatically lights the pilot. Do not try to light the pilot

by hand.

B. BEFORE OPERATING smell all around the appliance area

for gas. Be sure to smell next to the floor because some

gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.
Do not touch any electric switch; do not use any phone

in your building.

FOR YOUR SAFETY READ BEFORE OPERATING

Immediately call your gas supplier from a neighbor’s

phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire depart-

ment.

C. If any portion of this appliance does not operate as the

instructions indicate, do not try to repair it, call a qualified

service technician. Do not use tools. Force or attempted

repair may result in a fire or explosion.

D. Do not use this appliance if any part has been under

water. Immediately call a qualified service technician

to inspect the appliance and to replace any part of the

control system and any gas control which has been under

water.

OPERATING INSTRUCTIONS — ELECTRONIC

1. For complete shut-down, turn remote wall switch to "OFF" or

set the thermostat to the lowest setting, if applicable.

2. Turn the ON/OFF switch to “OFF”, if Step 1 is not applicable.

3. Close the main line shut-off valve.

TO TURN OFF GAS TO APPLIANCE

OPERATING INSTRUCTIONS

1. STOP! Read the safety information above on this Page.

2. Turn remote wall switch to "OFF" or set the thermostat to

lowest setting, if applicable.

3. Turn the ON/OFF switch to "OFF" if Step 2 is applicable,

this ON/OFF switch should always be in the "OFF" posi-

tion.

4. Verify main line shut-off valve is open.

5. This appliance is equipped with an ignition device which au-

tomatically lights the burner. Do Not try to light the burner

by hand.

6. Wait five (5) minutes to clear out any gas. Then smell

for gas, including near the floor. If you smell gas, STOP!

Follow “B” in the safety information above (to the left) on

this label. If you don’t smell gas, go to the next step.

7.

Turn "ON" all electrical power to appliance (remote wall

switch), or set the thermostat to the desired setting, if ap-
plicable.

8.

Turn the ON/OFF switch on the appliance to "ON", if

Step 7 is not applicable.

9. If the appliance will not operate, follow the instructions

"To Turn Off Gas To Appliance" and call your service tech-

nician or gas supplier.

TO SHUT OFF

1. Turn off all electrical power to the appliance (remote wall

switch) or set the thermostat to the lowest setting, if ap-

plicable.

HI

LO

Gas Valve

WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION

MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INjURY OR LOSS OF LIFE.

Advertising