Life Fitness 9100R - Manual (Page 6)

Step 1
Align the four holes in the SEAT BACK (#5) with those in
the SEAT BACK POSTS. Insert the four SCREWS (#1)
and WASHERS (#2) through the backside of the SEAT
BACK POSTS and into the SEAT BACK. Tighten the
four SCREWS with a hex key wrench.
NOTE: BE CAREFUL NOT TO OVER-TIGHTEN
THE SCREWS.
Step 2
Unfold the CONSOLE WIRE HARNESS from the POST
extending from the FRAME.
Step 3
Slide the COLLAR (#6) onto the HANDLEBAR ASSEMBLY (#7) with the angled side of the COLLAR facing toward
the HANDLEBAR.
Step 4
While holding the HANDLEBAR ASSEMBLY (with the
COLLAR in place) in one hand, feed the WIRE HARNESS
at the top of the FRAME POST through the bottom of the
HANDLEBAR ASSEMBLY COLUMN, as shown, with your
other hand. Continue pushing the WIRE HARNESS until the
CONNECTOR at the end of the WIRE HARNESS exits
through the opening at the top of the COLUMN. Gently pull
the WIRE HARNESS to remove the slack.
Step 5
Position the HANDLEBAR ASSEMBLY so that the
HANDLEBAR is facing the user and slide the HANDLEBAR
ASSEMBLY into the FRAME POST while being careful not
to pinch the WIRES in the process. Align the holes in the
bottom of the HANDLEBAR ASSEMBLY with those in the
FRAME POST. (Both the HANDLEBAR ASSEMBLY and the
FRAME POST are keyed to ease the alignment and
positioning). Install the two HANDLEBAR BOLTS (#3) to
secure it into position.
NOTE: BE VERY CAREFUL NOT TO DAMAGE THE WIRES WHEN PASSING THE BOLTS
THROUGH THE HOLES. TIGHTEN THE BOLTS SECURELY.
Step 6
There is a large hole in the rear of the DISPLAY
CONSOLE (#8) through which you can see a 16-PIN
CONNECTOR. This corresponds to the matching
WIRE HARNESS CONNECTOR protruding from the
top of the HANDLEBAR ASSEMBLY. Properly align
the LOCKING TABS of the 16-PIN CONNECTORS
and plug them together until they SNAP into place.