Life Fitness 9100R - Manual (Page 8)

OPERATION CHECKLIST
⇒
Insure that the STABILIZER BAR and HANDLEBAR BOLTS are tight.
⇒
Make sure the aerobic trainer is properly leveled and stable.
⇒
Read the entire Operation Manual before using the trainer.
English/Metric Default Setting Toggle
The default setting of the Lifecycle 9100R aerobic trainer display console is set to English units of measurements at the
factory. If your display console will require units of measurements to be in metric, it may be necessary to change the
setting from English to metric. To do so, you will need to enter into the diagnostic programs and proceed to Diagnostic
State 8. To do so, follow the instructions as listed below.
Press and continue to hold the ‘5’ key on the keypad and then press ‘START’ while pedaling the bike over 55 RPM.
On entry, all LED’s and 7-segment displays will be on. You are now in Diagnostic State 1. Press the START/ENTER
key seven times to forward to diagnostic state 8 and choose the default setting.
In ALL DIAGNOSTIC STATES, the user must keep pedaling the bike. If the pedal RPM drops too low, the bike will shut
down, requiring at least 40 RPM or greater and a START switch closure to operate again.
Diagnostic State 8:
This test indicates the display console default setting of English or metric units of measurements.
When the default is set to English units of measurements, it will read ‘ E ’ in the DATA ENTRY WINDOW.
When the default is set to metric units of measurement, it will read ‘ 9 ’ in the DATA ENTRY WINDOW.
The user can change the default setting of the system by pressing the ' 5 ' key. The system will toggle from an ‘ E ’ to ‘
9 ’ to ‘ E ’ condition by continuing to press the ' 5 ' key.
Diagnostic State 7 can be entered now by pressing the CLEAR/PAUSE key and you can continue going backwards by
pressing the CLEAR/PAUSE key through previous diagnostics until you return to the user display.
Before attempting to operate your Lifecycle 9100R trainer, it is imperative that you familiarize yourself with the contents
of the Operation Manual. If your aerobic trainer does not respond as described in the OPERATION MANUAL contact:
Prior to your call, please be sure you have located and noted the MODEL NUMBER & SERIAL NUMBER.
The Model & Serial number information of your Life Fitness 9100R aerobic trainer is contained in a label located under
the center of the front stabilizer bar.
Copyright 1996 Life Fitness. All rights reserved. The Life Fitness trademark is registered in the U.S. Patent and Trademark Office, Certificate
No. 1,400,502 issued July 8, 1986. Lifepulse and Zone Trainer are registered trademarks of Life Fitness. Any use of these trademarks, without
the express written consent of Life Fitness is forbidden. U.S. Patent Numbers 3,767,195 and 4,358,105.
M051-00K19-A045
5-96
Life Fitness Customer Support Services
at (800) 351-3737 or (847) 451-0036