Life Fitness 9100R - Manual (Page 7)

Step 7
Carefully feed the wire back into the top of the HANDLEBAR
ASSEMBLY and attach the DISPLAY CONSOLE to the
HANDLEBAR ASSEMBLY using the four CONSOLE SCREWS
(#4) and a phillips screwdriver. Tighten the four SCREWS in a
criss-cross pattern.
NOTE: BE CAREFUL NOT TO OVERTIGHTEN THE
SCREWS.
Step 8
To install the 9-VOLT ALKALINE BATTERY (#9) found in the parts bag use a Phillips screwdriver to remove the
screw from the back door. Gently pull the BATTERY WIRES from the back of the DISPLAY CONSOLE and connect
them to the 9-VOLT ALKALINE BATTERY. Carefully, tuck the BATTERY WIRES back into the DISPLAY
CONSOLE and set the BATTERY in place.
Re-install the BATTERY DOOR by inserting the bottom tab of the BATTERY DOOR into the corresponding slot in
the DISPLAY CONSOLE. Push the DOOR into place and tighten the screw with a Phillips screwdriver.
NOTE: ONLY USE AN ALKALINE TYPE BATTERY. USE OF ANY OTHER TYPE BATTERY
MAY RESULT IN A MALFUNCTION OR DAMAGE.
CAUTION!: BE CAREFUL NOT TO OVER TIGHTEN THE SCREW
Step 9
Slide the COLLAR (#6) down until it completely covers the HANDLEBAR ASSEMBLY HARDWARE and the POST
extending up from the FRAME. Secure the COLLAR by “pinching” in the sides and pushing down firmly. The
COLLAR will lock into place.
Step 10
After placing the Lifecycle in the intended location for use,
check the stability of the bike. If the Lifecycle is not level, turn a
LEVELER in the rear STABILIZER BAR in either direction until
the rocking motion diminishes.
NOTE: ONLY ONE LEVELER NEEDS TO BE TURNED.