Linksys Ethernet SGE2010 - Manual (Page 42)

SGE2010/SGE2010P Administration Guide 39
System Configuration
Using the Console
TraceRoute IPv6
You can use the TraceRoute IPv6 screen to run a trace route test for an IPv6 address.
To open the screen:
1. From the Switch Main Menu, select 1. System Configuration.
2. From the System Configuration Menu, select 6. IP Configuration.
3. From the IP Configuration menu, select 5. Network Configuration.
4. From the Network Configuration menu, select 4. Trace Router IPv6.
To change the IP address:
1. Select Edit, and then enter the IPv6 address.
2. Press the Esc key to move the cursor to the Action list.
To begin the trace route test:
1. Select Execute to begin the test.
2. After the test is complete, the results of the test appear on the screen.
3. When the Operation complete message appears, press the Esc key to move the cursor to the
Action list.