LevelOne WBR-1400TX - Manual (Page 90)

Advanced Configuration
Figure 48: Routing Screen
Data - Routing Screen
RIP
Enable RIP Check this to enable the RIP (Routing Information Protocol) feature
of the LevelOne Wireless Broadband Router.
The LevelOne Wireless Broadband Router supports RIP 1 only.
Static Routing
Static Routing
Table Entries This list shows all entries in the Routing Table.
• The "Properties" area shows details of the selected item in the
list.
• Change any the properties as required, then click the "Update"
button to save the changes to the selected entry.
Properties
• Destination Network - The network address of the remote LAN
segment. For standard class "C" LANs, the network address is
the first 3 fields of the Destination IP Address. The 4th (last)
field can be left at 0.
• Network Mask - The Network Mask for the remote LAN seg-
ment. For class "C" networks, the default mask is 255.255.255.0
• Gateway IP Address - The IP Address of the Gateway or Router
which the LevelOne Wireless Broadband Router must use to
communicate with the destination above. (NOT the router at-
tached to the remote segment.)
• Metric - The number of "hops" (routers) to pass through to reach
the remote LAN segment. The shortest path will be used. The de-
fault value is 1.
Buttons
Save Save the RIP setting. This has no effect on the Static Routing Table.
87