LevelOne WBR-1400TX - Manual (Page 80)

Dial-in
Client PCs - Using Dial-in
This section describes how to configure your PC to use the LevelOne Wireless Broadband
Router 's RAS Dial-in feature.
To use the RAS Dial-in feature of the LevelOne Wireless Broadband Router:
• An Analog Modem or ISDN TA must be connected to the Serial Port on the LevelOne
Wireless Broadband Router.
• The LevelOne Wireless Broadband Router 's Dial-in screen must be configured for Dial-in
access, and Dial-in Users must be created. See Chapter 7 - Dial-in for details.
• A suitable Dial-up connection must be created on your PC, as described below.
Creating a Dial-in Connection in Windows
You can use the standard Windows Dial-up Networking software normally used for Internet
access. The procedure is as follows:
1. Ensure your modem is installed and working.
2. Select
My Computer, then Dial-up Networking.
3. Click Make new Connection, and step through the Wizard.
4. Give this connection a suitable name.
5. Enter the area code and telephone number to connect to the LevelOne Wireless Broadband
Router.
6. Continue the Wizard until completed.
7. The default values for this connection will work with the LevelOne Wireless Broadband
Router 's default values. If necessary, you can adjust the Properties for the connection:
• In the Dial-up Networking window, select the connection.
• Right-click, and select Properties to see a screen like the one below.
Figure 43: Dial-up Networking Properties
77