LevelOne WBR-1400TX - Manual (Page 87)

LevelOne Wireless Broadband Router User Guide
Printer Port
Normally, these settings do not need to be changed.
Figure 46: Printer Port Screen
AppleTalk
AppleTalk zone This determines which Apple systems can gain access to this
printer. The default value is *, which allows access by all systems.
If you enter another zone name, only Apple systems in that zone
will be able to access the printer.
Printer Object Type Sets the type of printer attached. The default setting is "Laser-
Writer".
If the "Printer Object Type" is incorrect, the printer will not be
visible from your Apple system.
Communication
Protocol You must use the same setting as your Macintosh.
Logical Printers
No (L1, L2, L3) Logical printer configuration is only required if using LPD print-
ing under Linux or Unix. Otherwise, these settings are ignored
There are 3 Logical Printers (Ports), named L1, L2, and L3.
These names cannot be changed, and must be used when selecting
the logical printer from your Unix system.
Pre-string (HEX) Enter (in HEX) the series of printer commands to be sent to the
attached printer BEFORE each print job.
Post-string (HEX) Enter (in HEX) the series of printer commands to be sent to the
attached printer AFTER each print job.
LF to CR/LF If checked, Unix-style LF (line feed) characters at the end of each
line will be converted to CR/LF (carriage return/line feed) pairs,
as used in MSDOS and Windows.
84