Life Fitness Fitness Electronics - Manual (Page 21)

5
I
NTERNAL
S
ETTINGS
5.1 E
NTERING THE
M
ANAGER
’
S
C
ONFIGURATION
Manager's Configuration allows the operational characteristics of the Cross-Trainers to be set
up, such as the maximum workout time or enabling of pause or telemetry. It also displays statis-
tics on the hours of use and types of programs used.
To enter the Manager's Configuration, while the unit is off, press and hold down the Display
Lock key (or for CT 9500HR the numeric 2 key) and press the Start key. The console displays
"Manager's Configuration". Scroll through the configuration options using the Enter/Clear keys.
The options can be changed by using the Up or Down Arrow keys. All changes to the settings
are saved to the memory upon exiting the Manager's Configuration.
To exit Manager's Configuration, repeatedly press either the Clear (Clear/Pause) or Enter key
until the console displays "Press Enter to Begin".
5.2 T
HE
S
ETTINGS
This area will allow the user to see the current configuration about the system. The information
will cover the following areas:
Configuration Setting Factory Default Description
CT 8500 / CT 9100 / CT 9500HR
SHUTDOWN TIME: 60 seconds Shutdown time conserves the battery. It represents
the amount of time settings will be held in memory
when a workout is interrupted and pedaling ceases.
PROGRAM TIME: 60 seconds Program time conserves the battery. It represents the
amount of time the console will remain lit after
pressing Start. If another key is not pressed or
pedaling does not begin, it will shut down.
TELEMETRY (ON/OFF): ON* Telemetry allows the product to use the Polar® Heart
Rate Zone Training exercise chest strap to monitor
the heart rate.
ENGLISH/METRIC UNITS: ENGLISH The units of measure used by the equipment
(e.g. pounds or kilograms). CT 8500 setting is
based on region.
MAXIMUM WORKOUT DURATION: 60 minutes The maximum duration of a workout.
Can be adjusted from 60 to 99 minutes
CAL/HR and/or WATTS: DISABLED If enabled, display toggles calories per hour and/or
watts during a workout.
(Applies to CT 9500HR/CT 9100 only.)
METS: OFF If enabled, the level and calories LEDs turn off
and the MET value is displayed.
* For telemetry, standard default is ON for all models except CT 8500 in the U.S.A. and Canada, where telemetry is optional and
default is OFF.
21