Lexmark 5770 - Manual (Page 42)

Printing from DOS
36
Printing from DOS
To change DOS print settings from the printer software:
1
Open the printer's Control Program .
For help opening the Control Program, see
“Opening the Control Program” on page 8.
2
Click the DOS Printing Tab .
3
Change settings as needed.
4
Click OK to save the settings.
Note: When you make changes on the DOS Printing
Tab, they apply to DOS print jobs only. When
you make changes on other tabs, they apply to all
print jobs.
Printing from DOS
applications
This section describes how to print from:
• DOS applications in Windows
• native DOS (non-Windows) applications.
DOS applications in Windows
Use these instructions only if your application runs from
the DOS prompt in Windows. This section describes:
• printing from a DOS application
• printing from a DOS application to another printer
• printing to a file
Printing from a DOS application
When you print from a DOS application, your printer
uses PCL 3 emulation. You must install a printer driver
for PCL 3 emulation in each DOS application.
5700.book : dos.fm Page 36 Thursday, July 16, 1998 3:49 PM