Land Pride RCP2660 - Manual (Page 20)

18
Section 1: Assembly & Set-up
RCP2660, RCPM2660, RCP3060 and RCPM3060 Parallel Arm Rotary Cutter 316-111M 1/11/13
Table of Contents
Weight Hanger Assembly
Refer to Figure 1-11:
There are five different weight hangers that can be
attached to the reservoir. One of the five must be
installed for operation. See “Bolt-on Weight Hangers”
on page 35 for detailed description of available weight
hangers.
1. Attach weight hanger (#1) to reservoir with fourteen
1/2"-13 x 1 1/4" GR5 cap screws (#3) and hex flange
lock nuts (#3). Tighten lock nuts to the correct torque.
2. Attach manual storage container (#9) to the front
side of the reservoir with two 1/4"-20 x 1 1/4" GR5
cap screws (#4), flat washers (#7), and hex nylock
nuts (#6). Tighten nylock nuts to the correct torque.
3. Insert weight retainer pin (#2) through holes in
weight hanger and secure with hairpin cotters (#8).
Weight Hanger Installation
Figure 1-11
Gauge Wheels (Optional)
Refer to Figure 1-12:
The deck with gauge wheels is shipped from the factory
completely assembled to the parallel arm with the
exception of installing the rear ratchet jack and one
gauge wheel.
NOTE: Case/International Harvest weight hanger
includes an L-shaped spacer. Be sure to locate this
spacer between the weight hanger side plate and
hydraulic reservoir tank in assembly.
30029
Case/International Harvest Weight Hanger Only:
Locate L-shaped spacer between weight hanger
side plate and hydraulic reservoir.
Ratchet Jack Installation
1. Check 5/8" hex flange lock nuts securing bolts (#3).
They should be drawn up snug, not tight.
A-frame (#2) should pivot freely on the two bolts.
2. Cut ties securing A-frame (#2) and rotate frame back
to position it behind the deck as shown.
3. Attach ratchet jack (#8) to the cutter deck with 1" dia.
clevis pins (#6). Secure clevis pins with hairpin
cotters (#3).
4. Insert long handle in the rear ratchet jack and short
handle in the front ratchet jack. Secure handles with
cotter pins. Bend cotter pin legs to keep pins from
falling out.
Gauge Wheel Installation
1. Install 1 1/4" I.D. machine washer (#4) over yoke
spindle (#1) as shown.
2. Insert yoke spindle (#1) into the front support frame.
3. Install second 1 1/4" I.D. machine washer (#4) over
yoke spindle (#1).
4. Secure yoke spindle to frame with 5/16" dia. roll
pin (#7).
Gauge Wheel Installation
Figure 1-12
NOTE: Installation of gauge wheel and ratchet jack
is easier after the deck has been lowered. Therefore,
it is best to install them just before making “Float
Positioning Control Check” on page 20 for Tractor
Control or just before making “Float Switch ON/OFF
Push Button Check” on page 27 for Solenoid and
Independent Control.
NOTE: After deck cutting height is set, it is
recommended that the ratchet jack handles be
removed and stored with the tractor and cutter to
protect the deck finish.
24617