Land Pride RCP2660 - Manual (Page 36)

34
Section 5: Optional Equipment
RCP2660, RCPM2660, RCP3060 and RCPM3060 Parallel Arm Rotary Cutter 316-111M 1/11/13
Table of Contents
Parallel Arm Rotary Cutter Options
There are four options available.
Tractor Control Without Gauge Wheels:
Cutting deck is supplied without gauge wheels. Four
tractor duplex outlets are required to operate the parallel
arm cylinders, deck cylinder, and breakaway cylinder.
Tractor levers operate all cylinders.
Tractor Control With Gauge Wheels:
Cutting deck is supplied with gauge wheels for controlling
deck height and deck pivot in lieu of utilizing control
levers at all times. Four duplex outlets are required at the
tractor to operate the parallel arm cylinders, deck
cylinder, and breakaway cylinder. Tractor levers operate
all cylinders. “ARM 2” and “Deck Pivot” control levers are
set in float position when carrying the deck on its gauge
wheels.
Solenoid Control Without Gauge Wheels:
Cutting deck is supplied without gauge wheels. Two
duplex outlets are required to operate arm cylinders,
deck cylinder, and breakaway cylinder. Arm and deck
cylinders are solenoid activated with momentary push
button switches at the control stick. Breakaway cylinder
is controlled by tractor lever.
Solenoid Control With Gauge Wheels:
Cutting deck is supplied with gauge wheels for controlling
deck height and deck pivot in lieu of utilizing momentary
push button switches at all times. Two duplex outlets are
required to operate parallel arm cylinders, deck cylinder
and breakaway cylinder. Arm and deck cylinders are
solenoid activated with momentary push button switches
at the control stick. An “ON/OFF” push button Float
Switch is included on the control stick to bypass “ARM 2”
and “Deck Pivot” solenoids allowing the deck to float on
its gauge wheels. Breakaway cylinder is controlled by
tractor lever.
Independent Control without Gauge
Wheels:
Cutting deck is supplied without gauge wheels. One
duplex outlet is required to operate the breakaway
cylinder. Arm cylinders and deck pivot cylinders are
powered by a cylinder pump mounted on the back of the
motor pump. The motor on the deck is powered by the
motor pump connected to the tractor PTO shaft. Arm and
deck cylinders are solenoid activated with momentary
push button switches at the control stick. An “ON/OFF”
push button switch is included on the control stick to
activate the motor on the deck.
Independent Control with Gauge Wheels:
Cutting deck is supplied with gauge wheels. One duplex
outlet is required to operate the breakaway cylinder. Arm
cylinders and deck pivot cylinders are powered by a
cylinder pump mounted on the back of the motor pump.
The motor is powered by the motor pump connected to
the tractor PTO shaft. Arm and deck cylinders are
solenoid activated with momentary push button switches
at the control stick. An “ON/OFF” push button switch is
included on the control stick to bypass “ARM 2” and
“Deck Pivot” solenoids allowing the deck to float on its
gauge wheels. Also, an “ON/OFF” push button switch is
included on the control stick to activate the motor on the
deck.
Section 5: Optional Equipment