Lennox Hearth ADAGIO-EN - Manual (Page 11)

11
Figure 6 - Log Set and Glowing Embers
INSTALLING THE LOGS AND GLOWING EMBERS
A FIREBOX LINER KIT MUST BE INSTALLED BEFORE INSTALLING LOGS.
THIS APPLIANCE IS NOT APPROVED FOR OPERATION WITHOUT A
FIREBOX LINER KIT INSTALLED (SOLD SEPARATELY). SEE PAGE 17
FOR ORDERING INFORMATION. INSTALL LINER KIT AND LOG SUPPORT
BRACKET PER INSTRUCTIONS PROVIDED IN KIT.
Proper log and ember placement is critical to encourage outstanding flame
appearance and prevent sooting. These fires are designed to provide a
rich orange/red glow on the logs.
Note: Log setup is by design asymmetric. The fire is intentionally posi-
tioned off center to provide a natural fire look.
The information provided here is to be used in conjunction with the Care
and Operation Instructions in this document. Please read the Care and
Operation Instructions completely before completing the procedures
detailed in these placement instructions.
WARNING
• DO NOT attempt to install the logs until the appli-
ance installation has been completed, the gas
line connected and tested for leaks and the initial
burner operation has been checked out.
• The size and position of the log set was engineered
to give the appliance a safe, reliable and attrac-
tive flame pattern. Any attempt to use a different
log set in the fireplace will void the warranty and
will result in incomplete combustion, sooting, and
poor flame quality.
• Logs get very hot and will remain hot up to one
hour after gas supply is turned off. Handle only
when logs are cool. Turn off all electricity to the
appliance before you install logs and embers.
• This appliance is not designed to burn wood. Any
attempt to do so could cause irreparable damage
to the appliance and prove hazardous to your
safety.
• If logs are not installed according to the log installa-
tion instructions, flame impingement and improper
combustion could occur and result in soot and/or
excessive production of carbon monoxide (CO), a
colorless, odorless, toxic gas.
Complete the following before starting the log installation.
• READ WARNINGS ON THIS PAGE AND THROUGH-OUT MANUAL
BEFORE PROCEEDING
• Remove the front glass enclosure panel (see Glass Enclosure Panel
Removal Instructions, Page 10).
• If the logs are being installed for the first time, the following applies:
DO NOT attempt to install the logs until the appliance installation has
been completed, the gas line connected and tested for leaks and the
initial burner operation has been checked out. Locate; log set and bag
of embers. Handle logs carefully to prevent breakage.
Glowing Embers
Bag of Glowing
Embers (rockwool)
Separate into Quarter
Size (separate) Pieces
Locating Pins - 5 Places
Firebox
Ember Burner Ports
LOG SET
Catalog Number H1237
* Item Description
A Log, Rear
B Log, Left Middle
C Log, Right Middle
D Log, Left Front
E Log, Right Front
* Item "letters" above correspond to photos
D
C A
B
E
1
2
3 4
5
This appliance is provided
with enough Glowing Em-
bers for several applica-
tions, do not use all that is
in a new bag at one time.
For best glowing effect,
replace the ember material
annually.
Log Support Bracket
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.