Lennox Hearth ADAGIO-EN - Manual (Page 12)

12
1. Place the rear log (A) as shown in Figure 7 . Position the 2 holes on
the bottom of the log over the corresponding locating pins (#1 & #2)
and against the log support bracket. See Figure 6 for pin and rear
bracket locations.
2. Place the left middle log (B) as shown in Figure 8 . Position the hole
on the bottom of log B over the corresponding locating pin on Log A.
5. Place the right middle log (C) as shown in Figure 11 . Position log
C behind Log E and resting on the "flat" on Log A.
3. Place the left front log (D) as shown in Figure 9 . Position the hole
on the bottom of log D over pin# 3.
4. Place the right front log (E) as shown in Figure 10 . Position the hole
on the bottom of log E over pins #4 and # 5.
6. Ember Placement - Separate the Embers (rockwool) into pieces
about the size of a quarter (see Figure 6). Keep the pieces fluffed up,
not matted. Distribute these pieces over the surface of the burner, as
shown in Figure 12. Do not use more than is necessary. Ensure that
the main burner ports remain uncovered by the ember material.
A
Figure 7 - Install Rear Log (A)
B
A
Figure 8 - Install Left Middle Log (B)
Figure 11 - Install Right Middle Log (C)
Figure 9 - Install Left Front Log (D)
Figure 10 - Install Right Front Log (E)
1 2
Figure 12 - Ember Placement
DO NOT place ember material directly
over the ember burner ports.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
3 4
5
D
3
D
C
E
A
E