Lennox Hearth ADAGIO-EN - Manual (Page 8)

8
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Pilot
Adjustment
Screw
H I
L O W H T
P T
H T
P T
P I L O
T
P I L
O T
O N
t i
O F F
IN OUT
OFF
ON
HI/LO Variable
Flame Height
Adjustment Manifold
Pressure Tap
Inlet Pressure
Tap
Main Gas
Control Knob
OFF/PILOT/ON
Piezo Igniter Standard Burner OFF/ON
Rocker Switch
Millivolt Appliances - To light millivolt ap-
pliances refer to Figure 1. Detailed lighting
instructions are found on Pages 19 and 20. Mil-
livolt appliance lighting instructions may also
be found on the pull out lighting instruction
labels attached to the gas control valve.
Millivolt appliances are fitted with an ON/OFF
rocker switch for appliance ON/OFF control.
See Figure 1 for its location. Once the pilot is
lighted, the ON/OFF rocker switch will control
the appliance ON/OFF operation. To operate:
Toggle the switch between its ON and OFF
positions.
If your millivolt appliance is equipped with an
optional remote switch kit (wall switch, remote
control, rocker switch, or wall thermostat) and
the pilot is lit, the appliance main burner may be
turned on and off using the optional switch.
H I
L O W H T
P T
H T
P T
P I L O
T
P I L
O T
O N
t i
O F F
IN OUT
OFF
ON
Gas Controls/Control Compartment Access
The gas controls can be found behind the bot-
tom control panel. Open the bottom control
panel (see instruction sheet provided with the
facade kit for additional information about the
control panel).
On millivolt systems, the piezo igniter, Hi/Lo
flame adjustment knob, and pilot and main gas
ON/OFF control knob are located in the control
compartment. See Figure 1.
Operation of millivolt and electronic gas con-
trol systems are different. Before lighting and
operating your appliance determine if you have
a millivolt or electronic appliance.
Refer to Figure 1 for access to the gas control
valve. Millivolt appliances is fitted with the gas
control valve shown in Figure 2.
Appliances with electronic systems is fitted
with the electronic valve shown in Figure 3.
Familiarize yourself with the gas control valve
that your appliance uses.
Figure 2 - SIT Millivolt Gas Valve
Gas Valve Burner
ON/OFF Switch
Push Button
Piezo Igniter
Glass Door
Gas Shut-
Off Valve
Gas Flex-
Line
Figure 1 - Control Compartment
OPERATION AND CARE OF YOUR APPLIANCE
WARNING
Young children should be carefully supervised when they are in the
same room as the appliance. Toddlers, young children and others
may be susceptible to accidental contact burns. A physical barrier is
recommended if there are at risk individuals in the house. To restrict
access to a fireplace or stove, install an adjustable safety gate to keep
toddlers, young children and other at risk individuals out of the room
and away from hot surfaces.
AVERTISSEMENT
Les jeunes enfants devraient être surveillés étroitement lorsqu’ils se trou-
vent dans la même pièce que l’appareil. Les tout petits, les jeunes enfants
ou les adultes peuvent subir des brûlures s’ils viennent en contact avec
la surface chaude. Il est recommandé d’installer une barrière physique
si des personnes à risques habitent la maison. Pour empêcher l’accès
à un foyer ou à un poêle, installez une barrière de sécurité; cette mesure
empêchera les tout petits, les jeunes enfants et toute autre personne à
risque d’avoir accès à la pièce et aux surfaces chaudes.
Electronic Appliances - To light electronic appli-
ances refer to the detailed lighting instructions
found in both English and French on Pages 21
and 22 of these instructions. Electronic appli-
ance lighting instructions may also be found on
the pull out lighting instruction labels attached
to the gas control valve.
Electronic appliances are fitted with an ON/OFF
rocker switch for appliance ON/OFF control. See
Figure 1 for its location.
Once the pilot is lighted, the ON/OFF rocker
switch will control the appliance ON/OFF opera-
tion. To operate: Toggle the switch between its
ON and OFF positions.
If your electronic appliance is equipped with an
optional remote wall switch, wall thermostat or
remote control kit the appliance main burner
may be turned on and off with the wall switch,
wall thermostat or remote control.
Pilot
Adjustment
Screw
HI/LO Variable
Flame Height
Adjustment
Manifold
Pressure Tap
Inlet Pressure
Tap
Standard Burner
OFF/ON Rocker
Switch
Figure 3 - SIT Electronic Gas Valve
HI
LO
OFF
ON
Variable Flame Height Adjustment
All millivolt and electronic appliances are
equipped with a variable gas control valve. Flame
height for these models may be adjusted through
a range between fixed low and high settings while
the appliance is in operation. Adjust the flame
height as desired after lighting the appliance by
rotating the variable adjustment control knob
(HI/LO) located on the front of the valve (refer
to Figures 2 and 3).