Life Fitness 880 - Manual (Page 14)

FIGURE 9
STEP 9:
14
• Insert two GUIDE RODS (5) into the BASE FRAME (9) as shown on FIGURE 4. (NOTE: If the 880 SHROUD OPTION was
purchased, place the GUIDE RODS (5) through the BOTTOM SHROUD BRACKET (found in SHROUD OPTION box)
and into the BASE FRAME (9) as shown in FIGURE 9.
• Slide two WEIGHT STACK SPACERS (20), two 3/4” FLAT WASHERS (79), and two WEIGHT STACK CUSHIONS (67) down
over the GUIDE RODS (5).
• Using EXTREME CARE slide all fifteen WEIGHT PLATES (115) (NOTE: If 50-LB. ADD-ON KIT was purchased, slide twenty
WEIGHT PLATES and discard two WEIGHT STACK SPACERS (20), two 3/4” FLAT WASHERS (79) use the 50 LB. ADD-
ON HEAD PLATE and refer to the 50 LB. ADD-ON Kit instructions) down over the GUIDE RODS (5) on to the WEIGHT
STACK CUSHIONS (67). Make sure that the WEIGHT PLATES (115) are all facing as shown.
• Slide the head plate assembly down over the GUIDE RODS (5) onto the weight stack.
• Slide two SHAFT COLLARS (59) over the GUIDE RODS (5) as shown in FIGURE 9.
• (NOTE: Lubricate GUIDE RODS (5) with silicon or teflon spray available at most hardware stores.)
880 SHROUD
OPTION ONLY!
9
20
114
115
51
5
59
• Apply WEIGHT STACK LABELS (114) to WEIGHT PLATES (115) and HEAD PLATE (51) as shown in FIGURE 9. Begin with
number one at the HEAD PLATE (51) with larger numbers in consecutive order towards bottom of weight stack.
OPTIONAL 50
LB. ADD-ON KIT
67
79