Life Fitness 880 - Manual (Page 24)

FIGURE 24
24
STEP 24:
33
113
112
• SECURELY assemble the SPRING PIN ASSEMBLY of the PUSH/PULL CABLE to the spring pin barrel on the EXTERIOR
PRESS ADJUST (33). (!!! IMPORTANT !!! TIGHTEN THE NUT OF THE SPRING PIN ASSEMBLY SECURELY)
• Swing the PRESS ARM (38) up until the SPRING PIN of the PUSH/PULL CABLE engages in one of the adjustment holes on the
INTERIOR PRESS ARM ADJUST (34).
• Thread the second 1/4” NUT onto the threaded end of the CABLE, and cinch the two 1/4” NUTS around the flat on the EXTERIOR
PRESS ADJUST (33). (IMPORTANT! DO NOT OVER TIGHTEN NUTS!)
• Use the extra thread on the end of the PUSH-PULL CABLE to adjust out slack. ( !!! DO NOT ADJUST OUT TO FAR !!!
ALWAYS ALLOW SPRING PIN ASSEMBLY TO FULLY ENGAGE)
38
34
PUSH-PULL
CABLE
• Insert the 1/8” ROLL PIN (112) thru the EXTERIOR PRESS ADJUST (33) and into the small hole on the SPRING PIN. (NOTE:
Hammer may be needed to pound in PIN.) Assemble BUMPER CAP (113) to the 1/8” ROLL PIN (112) as shown in FIGURE
24.
SPRING PIN
BARREL
1/4” NUTS