Life Fitness FIT SERIES - Manual (Page 11)

11
FIGURE 10
STEP 10:
1
27 3/8 X 67mm
13
34
10
44
TIGHTEN!
22
• Slide the 13/16” SHAFT COLLARS (22) up against the GUIDE ROD SUPPORT (10) and SECURELY tighten the set screws on the
SHAFT COLLARS (22). See FIGURE 10.
• Route the threaded end of the WEIGHT STACK CABLE (13) through the GUIDE ROD SUPPORT (10) and SECURELY assemble the
GUIDE ROD SUPPORT (10) to the TOWER (1) using two 3/8 X 67mm BOLTS (27), four 3/8” FLAT WASHERS (44) and two 3/8” LOW
HEIGHT LOCK NUTS (34) as shown in FIGURE 10.
20
21
• Slide one WEIGHT STACK PIN (21) over the stem on the HEAD PLATE (20) as shown in FIGURE 10.
• LOOSELY thread end of the WEIGHT STACK CABLE (13) into the end of the stem on the HEAD PLATE (20). See FIGURE 10.
(NOTE: Cable adjustment will be made in a later step.)