Life Fitness FIT SERIES - Manual (Page 14)

14
• Route the LEG PRESS CABLE (14) through the horizontal bracket on the LEG PRESS FRAME (2) and SECURELY assemble one 4-1/
2” PULLEY (16) to the bracket using two RH CAPS (38), two 3/8 X 43mm BOLTS (25), two 3/8” SAE WASHERS (35) and two 3/8”
RH WASHERS (36) as shown in FIGURE 14. (NOTE: Make sure CABLE runs over top of retaining bolt.)
STEP 14:
FIGURE 14
25 3/8 X 43mm
36
38
34
35
2
16
14
8
3/8 X 43mm 25
16
• Route the LEG PRESS CABLE (14) through the vertical bracket on the TOWER (1) and SECURELY assemble one 4-1/2” PULLEY
(16) to the bracket using two RH CAPS (38), one 3/8 X 43mm BOLT (25), two 3/8” SAE WASHERS (35), two 3/8” RH WASHERS
(36) and one 3/8” LOW HEIGHT LOCK NUT (34) as shown in FIGURE 14. (NOTE: Make sure CABLE runs over top of retaining
pin.)
• Route the LEG PRESS CABLE (14) through the hole on the UPPER SUPPORT (8) as shown in FIGURE 14.