Lathem PC3500TX - Manual (Page 15)

PC3500TX Terminal Installation & User’s Guide - 11
This is the system Router used for directing network traffic. (See your network
administrator for assignment.)
Enter the numeric Router or Gateway address in blocks of three followed by the ENTER
key.
The following message will be displayed:
ENETADD=XXXXXXXXXXXX
SETUP COMPLETE
The XXXXXXXXXXXX represents the unique Ethernet address programmed into the
EPROM by the factory. (Also known as the MAC Address)
Important: Write this number down on the Terminal Data Sheet and on the
Terminal sticker. This number is unique to each Terminal and may be needed for
future troubleshooting.
To exit the Setup Mode, place the TEST/USE switch to the USE position and press the
CLEAR key. The terminal will goes through its power up sequence. The terminal
displays: “TERMINAL LOCKED”. The terminal can now accept a download.