Lathem PC3500TX - Manual (Page 8)

4 - PC3500TX Terminal Installation & User’s Guide
To install the mounting bracket
♦ Locate a flat wall surface. Make sure you can plug the terminal into a 110VAC wall
outlet (220VAC in Europe and other areas), which should be no farther than 4 feet
from the terminal.
♦ Place the bottom of the mounting template on the wall 48 inches from the floor and
tape the template into place.
♦ Drill the 3 holes noted on the template using a 5/16” drill bit. If wires will be routed
through the wall, drill up to a 3/4" hole as indicated on the template. Remove the
template.
♦ Insert a wall anchor in each of the 5/16" holes and tap with a hammer until flush
with the wall.
♦ Align the mounting bracket with the anchors, (pull wiring through the hole in the
middle of the case if wires are being routed from the wall), insert the 3 screws and
tighten with a phillips head screwdriver.