Lennox Hearth Winslow (PS40) - Manual (Page 28)

8
REPLACEMENT PARTS
Orange Sooty Flames - Glass Turns Black
Possible Problem Solution
Burn-Pot is dirty Clean the Burn-Pot
Vent pipe restricted Clean the vent pipe
Flue gas passageways restricted Clean the passageways
Combustion blower dirty Clean the combustion blower
Burning improper fuel Burn only wood pellet fuel or corn fuel that meets the fuel speci-
fications outlined on Page 5
Pellets Not Feeding
Possible Problem Solution
Hopper empty Fill the hopper
Auger jammed Call service technician
Flue gas passageways restricted Call service technician
Auger motor not operating Call service technician
Winslow PS40 stove
Cat. No. Description
H6006 Adjustable Latch Pin
H3111 Ash Clean Out Cover, 2 Per Stove
H3113 Ash Drawer
H5912 Ash Drawer Latch W/hardware 2 Per Stove
H5886 Auger Motor
H5921 Auger W/lower Bearing
H5875 Blower Snap Switch
H5856 Cast Burn-Pot
H5899 Clean-out Cover Gasket
H6018 Combustion Blower
H5900 Combustion Gasket Housing To Stove
H5903 Combustion Gasket Motor To Housing
H5917 Control Board Access Latch
H5978 Control Board
79020 Control Board Fuse 3amp, 5pk
H5884 Convection Blower
H5902 Convection Blower Gasket
H5904 Door Gasket 1 Ft (7ft Per Door)
H3112 Door Handle Assembly
79040 Door W/glass (No Trim)
H6037 Flue Restrictor W/hardware
H5911 Hopper Door Wire
79021 Igniter Fuse 6amp, 5pk
H6005 Igniter W/hose Clamp
H5891 Overtemp Switch
H5660 Power Cord
H5887 Proof Of Fire Switch
H3114 Side Ash Cover Clean Out
H6174 Side Door, Left
H5916 Side Door Magnet
H5833 Side Door W/control Access, Right
H5832 Stove Back
H6035 Stove Back Cover Plate
H6036 Top Side Door Bracket, Right
H6175 Top Side Door Bracket, Left
H5898 Vacuum Line 12” Piece
H5889 Vacuum Switch
H5892 Wiring Harness
70K99 Paint Touch-Up Kit, Black
Over Temperature Snap Switch Shuts Stove Down - Code - Ready light flashes red  long blinks
Possible Problem Solution
Convection blower not running Blower dirty, blower snap switch bad, or blower broken
Flue passageways or vent restricted Clean passageways or vent pipe (see Pages 22 and 23)
Snap switch* defective Replace the snap switch*
* Note: The snap switch has a reset button that must be pushed before stove will function (see Page 25).