LevelOne 4-bay Sata NAS w/2 Gigabit Ethernet GNS-8000B - Manual (Page 10)

- 10 -
3. Place a hard disk in a hard disk tray.
4. Turn over the disk tray. Make sure the disk holes match the holes at the base
of the tray. Fasten the disk with four flat head screws.
5. Insert the hard disk tray to GNS-8000B. Then lock the tray with the hard disk
lock. (You can install 4 disks at maximum.)
6. When finished, close the front panel of GNS-8000B. Note that all disks should
be inserted in order from left to right (HDD1~HDD4).
Note: You can install 1~4 hard disks depending on the type of disk
configuration you select for GNS-8000B. If less than 4 disks are installed
and the server is turned on, the system will beep continuously. In such
case, please go to Hardware Settings in System Tools (refer to Chapter
6.9.4) and disable the buzzer. You can then continue to use GNS-8000B.
Tray front
Base
Back
Front
Insert the disk tray
Close the front panel
HDD4
HDD3
HDD2
HDD1