LevelOne 4-bay Sata NAS w/2 Gigabit Ethernet GNS-8000B - Manual (Page 74)

- 74 -
6.9.4 Hardware
Settings
You can enable or disable the hardware functions of GNS-8000B.
i. Enable LCD panel setting function
To enable users to configure TCP/IP settings via the LCD panel.
ii. Enable configuration reset switch
By enabling this option, you can press the reset button for a few seconds to
reset the administrator password and system settings to default.
iii. Enable buzzer
When buzzer is enabled, an alert sound will be played in case of system error.
iv. Power Supply Type
Select power supply type. There is one power supply by default. Do NOT
change the position of default power supply. To use a second power
supply, you can purchase from the distributor.
To use two power supplies, follow the steps below:
1. Set power supply type as Redundant.
2. Shut down the system properly.
3. Insert the second power supply and turn on the system.
If a power supply fails, the system will send an alert notification to the
administrator.