Linksys SLM224G4S - Manual (Page 22)

Chapter  Configuration Using the Web-based Utility
1 24/48-Port 10/100 + 4-Port Gigabit Resilient Clustering Smart Switch with 2 Combo SFPs
DNS Server The IP address of your ISP’s server that
translates the names of websites into IP addresses. This
setting can be configured from the Setup tab’s Network
Settings screen.
Default Gateway The IP address (default 0.0.0.0) of the
gateway router between the Switch and management
stations on other network segments. This setting can be
configured from the Setup tab’s Network Settings screen.
NOTE: The Default Gateway cannot be
configured if the system IP address is set to
192.18.1.24. (The system IP Address is set
using Setup > Network Settings.)
Address Mode Specifies whether the Switch’s IP address
is Static or dynamically assigned using DHCP (Dynamic
Host Configuration Protocol). This setting can be
configured from the Setup tab’s Network Settings screen.
The default setting is Static.
Base MAC Address Displays the Switch’s MAC address.
Jumbo Frame This setting enables or disables Jumbo
frames on the Switch. A maximum packet size of 9 KB is
supported. Jumbo frames allow data to be transmitted
using fewer frames, providing lower overhead, quicker
processing time, and fewer interruptions. Select either
Enable or Disable (default).
NOTE: The Jumbo Frame feature functions only
on the Gigabit ports (G1-G4).
Switch Mode After Reset This setting specifies the
system mode following a system reset. Select either
Standalone or Stackable (default).
System Information
Model Name Displays the model name of the Switch.
Hardware Version Displays the current hardware version.
Boot Version Displays the current boot version.
Firmware Version Displays the current software version
System Location Displays the location of the system if it
has been defined. This setting can be configured from the
Setup tab’s Network Settings screen.
System Contact The name of the administrator appears
here, if one has been defined. This setting can be configured
from the Setup tab’s Network Settings screen.
System Up Time Displays the length of time that has
elapsed since the Switch was last reset.
Current Time Displays the current time. This setting can
be configured from the Setup tab’s Time screen.
Click Save Settings to save your changes. Click Cancel
Changes to cancel your changes.
Setup > Zoom
The Zoom screen depicts the status of all the ports in the
system. This screen displays a front-panel view of each
Switch. The color of each switch port indicates its status:
Green This port has a connection.
Gray This port has no connection.
Orange The administrator has closed down this port.
Setup > Zoom
Clicking on a port displays the Port Configuration screen.
NOTE: The port colors in the Zoom screen are
not related to the colors of the port LEDs. The
port LEDs display different status information,
as described in “Chapter 2: Overview.”
Setup > Network Settings
Setup > Network Settings