Linksys SLM224G4S - Manual (Page 50)

Chapter  Configuration Using the Web-based Utility
44 24/48-Port 10/100 + 4-Port Gigabit Resilient Clustering Smart Switch with 2 Combo SFPs
Query
Interface Use this to query the table for a specific port or
LAG. Select Port or LAG and select the interface from the
drop-down menu.
MAC Address Use this to query the table for a specific
MAC address. Enter the MAC address in the field.
VLAN ID Use this to query the table for a specific VLAN ID.
Enter the VLAN ID in the field.
Address Table Sort Key Specifies how the search results
will be sorted—by Address, VLAN, or Interface.
Specify the search criteria (Interface, MAC Address, or
VLAN) and the sort method for the search results, then
click Query to display the dynamic addresses matching
the search criteria.
Admin > Port Mirroring
Port mirroring monitors and mirrors network traffic by
forwarding copies of incoming and outgoing packets
from one port to a monitoring port. Port mirroring can be
used as diagnostic tool and/or a debugging feature. Port
mirroring also enables switch performance monitoring.
Network administrators configure port mirroring by
selecting a target port to which the packets are copied,
and the source port(s) from which the packets are copied.
Port mirroring supports a maximum of one target port
and four source ports.
Admin > Port Mirroring
Set the following attributes for port mirroring using the
Port Mirroring screen.
Target Port The port that will mirror the traffic on the
source port.
Source Port The port whose traffic will be monitored.
Type Allows you to select which traffic to mirror to the
target port; receive, transmit, or both.
RxOnly (Default) Mirror only received traffic.
TxOnly Mirror only transmitted traffic.
Both Mirror both received and transmitted traffic.
Specify the source port, the traffic type to be mirrored, and
the target port, then click Add to List. The mirror session
is displayed in the text box.
Admin > Cable Test
The Cable Test screen uses Time Domain Reflectometry
(TDR) technology to test the quality and characteristics of
a copper cable attached to a port. The cable being tested
can be up to 120 m in length. Before you can perfom the
test, the port to which the cable is connected must be in
the down state.
Admin > Cable Test
The Cable Test screen contains the following fields.
Unit No. The unit to which the test cable is connected.
Port The port to which the test cable is connected.
Test Result The results of the test. Possible values are:
OK The cable passed the test.
No Cable No cable is connected to the port.
Open Cable The cable is connected on only one side.
Short Cable A short has occurred in the cable.
Undefined The test could not be properly performed.
Last Update Displays when the last cable test was
performed on the port.
Test Click this to start testing the cable attached to the
port. The test results will appear in the Test Result column.
•
•
•
•
•
•
•
•