Life Fitness 93X User Manual
Page 8
1.2
S
ETUP
Read the Operation Manual before setting up the Life Fitness Fit Stride Total Body Trainer.
W
HERE TO
P
LACE THE
L
IFE
F
ITNESS
F
IT
S
TRIDE
T
OTAL
B
ODY
T
RAINER
Following all safety instructions in Section 1.1, move the Cross-trainer to the location in which it
will be used. See Section 7, titled Specifications, for the dimensions of the footprint. Allow one
foot of clearance in front of the Cross-trainer to allow for movement of the pedal levers. It should
be easy to mount the Cross-trainer from the side.
H
OW TO
S
TABILIZE THE
L
IFE
F
ITNESS
F
IT
S
TRIDE
T
OTAL
B
ODY
T
RAINER
After placing the Life Fitness Fit Stride Total Body Trainer in position, check the unit’s stability by
attempting to rock it. Any slight rocking indicates that the unit must be leveled. Check the front
stabilizing feet to determine which foot does not rest fully on the floor. Rotate the foot counter-
clockwise to lower it. Recheck the stability and adjust again as needed until the Life Fitness Fit
Stride Total Body Trainer is stable and no longer rocks. Lock the adjustment into position by
tightening the jam nut against the stabilizer bar with an open end 17mm wrench.
.
C
HECK FOR
P
OWER
The Life Fitness Fit Stride Total Body Trainer console is powered by a rechargeable 6-volt bat-
tery. Check the battery by pressing the START key. The console should light up, and the MES-
SAGE CENTER should display a prompt to set up a workout. If this does not occur, mount the
Life Fitness Fit Stride Total Body Trainer and begin pedaling. The console should then light up,
making it possible to program a workout. Pedal for 10 to 20 minutes at 1.5 mph (2.4 km/h) or
faster during a workout to charge the battery. Afterwards, the pedal action during workouts
keeps the battery charged. If the console still does not light, contact Life Fitness Customer
Service. See section 6.5, titled How to Obtain Product Service, for more information.
F
ITNESS AND
E
NTERTAINMENT
N
ETWORKING
The Life Fitness Fit Stride Total Body Trainer may be connected via CSAFE protocol to a fitness
entertainment system and/or a fitness network, such as the FitLinxx
TM
interactive fitness network.
Contact Life Fitness Customer Support Services to purchase networking kits. See section 6.5, titled
How to Obtain Product Service, for more information.
•
Fitness network: The network connection enables the console to upload user workout
statistics to a fitness network database or to download remotely stored information, such
a pre-set workout program. See Section 4.2, titled Using the Workouts, for information
on logging onto a network.
•
Entertainment: The network connection enables the console to power a third-party
receiver for use with a service such as the Cardio Theater
®
entertainment system or the
BroadcastVision
TM
entertainment system.
7