Lexmark 302 - Manual (Page 77)

4. Look through the front bottom opening in the printer and find the
metal bar at the bottom of the forms device.
5. Grasp the metal bar with BOTH hands and pull firmly toward you
and then upward until both ends LOCK into place.
B o t t o m o f F o r m s D e v i c e
M e t a l B a r
6. To be sure that you have installed the forms device correctly,
look at the following figure and compare it to your printer. Check
both the left and right sides. Are the
clips around the platen rod
as shown? If so, you installed the forms device correctly. If not,
repeat Steps 3 on page 1-54 through 5.
P l a t e n R o d
C l i p
P l a t e n R o d
C l i p
Chapter 1. Setting Up the 4232 Printer Model 302 1-55